Honda CR-V: Armrests

Each front seat has an armrest on

Each front seat has an armrest on the side of the seat-back. To use it, pivot it down.

The rear seat armrest is in the

The rear seat armrest is in the center of the rear seat. Pivot it down to use it.

READ NEXT:

 Cargo Pass-through

The rear center seat-back has a cargo area pass-through. To use the cargo area pass-through, pull up the release on top of the center seatback and fold it down. If your vehicle is equippe

 Head Restraints

See page for important safety information and a warning about improperly positioning head restraints. Your vehicle is equipped with head restraints in all seating positions to help protect yo

 Reclining the Front Seats

You can recline the seat-backs on the front seats so they are level with the rear seat cushions, making a large cushioned area. To do this: EX-L and Canadian EX models Only the passengerâ€

SEE MORE:

 Component Replacement/Inspection After Deployment

NOTE: Before doing any SRS repairs, use the HDS SRS menu method to check for DTCs; refer to the DTC Troubleshooting Index for the less obvious deployed parts (seat belt tensioners, front impact sensors, side airbag sensors, etc.) Do not replace the ODS unit unless it is physically damaged or

 DTC 11, 13, 15, 17: Wheel Sensor (Open/Short to Body Ground/Short to Power)

1. Turn the ignition switch ON (II). 2. Check for DTCs with the HDS. Is DTC 87 indicated with DTC 11,13,15, and/or 17 at the same time? YES-Go to step 9. NO-Go to step 3. 3. Clear the DTC with the HDS. 4. Turn the ignition switch OFF, then turn it ON (II) again. 5. Check for DTCs with the HDS.

© 2016-2025 Copyright www.hcrv.net