Honda CR-V: WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

READ NEXT:

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

 Daytime Running Lights

With the headlight switch in the off or position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II)

SEE MORE:

 Cable Reel Replacement

Removal 1. Make sure the front wheels are aligned straight ahead. 2. Disconnect the negative cable from the battery, and wait at least 3 minutes. 3. Remove the driver's airbag. 4. Disconnect the connector (A) from the cable reel, then remove the steering wheel bolt (B). 5. Confirm that the front

 Owner’s Maintenance Checks

You should check the following items at the specified intervals. If you are unsure of how to perform any check, turn to the appropriate page listed. Engine oil level - Check every time you fill the fuel tank. Engine coolant level - Check the radiator reserve tank every time you fill

© 2016-2026 Copyright www.hcrv.net