Honda CR-V: PCV System

Component Location Index

Honda CR-V. PCV System

PCV Valve Inspection

1. Check the PCV valve (A), hoses (B), and connections for leaks or restrictions.

Honda CR-V. PCV System

2. At idle, make sure there is a clicking sound from the PCV valve when the hose between the PCV valve and intake manifold is lightly pinched (A) with your fingers or pliers.

If there is no clicking sound, check the PCV valve washer for cracks or damage. If the washer is OK, replace the PCV valve and recheck.

Honda CR-V. PCV System

PCV Valve Replacement

1. Disconnect the PCV hose.

2. Remove the PCV valve (A).

Honda CR-V. PCV System

3. Install the parts in the reverse order of removal with a new washer (B).

READ NEXT:

 EVAP System

Component Location Index EVAPORATIVE EMISSION (EVAP) CANISTER PURGE VALVE Replacement POWERTRAIN CONTROL MODULE (PCM) General Troubleshooting Information Replacement

 DTC Troubleshooting

 DTC P0443: EVAP Canister Purge Valve Circuit Malfunction

Special Tools Required Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A or equivalent, commercially available. NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and revie

SEE MORE:

 No sound is heard from speaker(s) (display is normal) (with navigation)

NOTE: Set the fader and balance positions to the center. Before doing symptom troubleshooting, do the power switch will not turn ON troubleshooting. 1. Check that the volume button is not set to the MIN level. Is it at MIN level? YES-Raise the volume level, and recheck the function. NO-Go to

 Wipers/Washers

Component Location Index WINDSHIELD WIPER BLADES WIPER/WASHER SWITCH WINDSHIELD WIPER ARMS and LINK WINDSHIELD WIPER MOTOR UNDER-DASH FUSE/RELAY BOX UNDER-HOOD FUSE/RELAY BOX INTERMITTENT WIPER RELAY CIRCUIT (Built into the MICU) REAR WIPER BLADE REAR WIPER ARM REAR WINDOW WIPER MOT

© 2016-2026 Copyright www.hcrv.net