Honda CR-V: Navigation Unit Removal/Installation

SRS components are located in this area. Review the SRS component location.

Also review the precautions and procedures in the SRS section before doing repairs or service.

NOTE:

1. Make sure you have the 4-digit anti-theft code for the navigation system, then write down the XM radio presets.

2. Remove the center vent and HVAC control unit.

3. Remove the navigation unit mounting bolts (A).

Honda CR-V. Navigation System

4. Pull the navigation unit away from the dashboard to release the locking clips (B), then disconnect the connectors (C).

5. Remove the bolts, screws, and the brackets (A), then remove the center panel (B).

Honda CR-V. Navigation System

6. Install the navigation unit in the reverse order of removal, and note these items:

Voice Control Switch Test

1. Remove the voice control switch.

Honda CR-V. Navigation System

2. Measure the resistance between the No.2 and No. 3 terminals in each switch position according to the table.

Honda CR-V. Navigation System

3. If the resistance is not as specified, replace the voice control switch.

4. Use a diode tester between the terminals in each switch position according to the table.

Honda CR-V. Navigation System

5. If the diode test is bad, replace the switch.

Voice Control Switch Replacement

1. Remove the steering wheel.

2. Remove the voice control switch.

3. Install the voice control switch in the reverse order of removal.

Microphone Replacement

1. Remove the front individual map light lens (A).

Honda CR-V. Navigation System

2. Disconnect the 3P connector (B) from the microphone.

3. Carefully pry off the microphone (C) from the map light housing (D) while pressing in on the retaining tabs (E).

4. Install the microphone in the reverse order removal.

Rearview Camera Removal/Installation

1. Remove the tailgate lower trim panel.

2. Disconnect the connector (A) from the rearview camera (B), then remove the wire harness clip (C).

Honda CR-V. Navigation System

3. Remove the rearview camera.

4. Install the rearview camera in the reverse order of removal.

GPS Antenna Removal/Installation

1. Remove the navigation unit.

2. Remove the center upper lid.

3. Remove the wire harness clips (A), screws and GPS antenna (B).

Honda CR-V. Navigation System

4. Install the antenna in the reverse order of removal.

 

Audio, Navigation, and Telematics

Special Tools

Honda CR-V. Special Tools

  1. Diagnostics CD

  2. Skip Test CD

  3. Skip Test CD

READ NEXT:

 Restraints

 Seat Belts

Component Location Index REAR CENTER SEAT BELT REAR CENTER SEAT BELT BUCKLE and LEFT REAR SEAT BELT BUCKLE REAR SEAT BELT FRONT SEAT BELT FRONT SEAT BELT BUCKLES RIGHT FRONT SEAT BELT LOWER A

 SRS (Supplemental Restraint System)

Component Location Index SRS INDICATOR SIDE AIRBAG CUTOFF INDICATOR MEMORY ERASE SIGNAL (MES) CONNECTOR (2P) (YELLOW) CABLE REEL PASSENGER'S AIRBAG CUTOFF INDICATOR FRONT PASSENGER'S AIRB

SEE MORE:

 Brake Booster

Brake Booster Test Functional Test 1. With the engine stopped, press the brake pedal several times to deplete the vacuum reservoir, then press the brake pedal hard, and hold it for 15 seconds. If the brake pedal sinks, either the master cylinder is bypassing internally, or the brake system is lea

 DTC P2227: BARD Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P0101, P0108, P1128, and/or P1129 are stored at the same time as DTC P2221, troubleshoot those DTCs first, then recheck for DTC P2221. 1. Turn the ignit

© 2016-2026 Copyright www.hcrv.net