Honda CR-V: Beverage Holders

Be careful when you are using the beverage holders. A spilled liquid that is very hot can scald you or your passengers. Liquid can also spill from the door pocket beverage holders when you open or close the doors. Use only resealable containers in the door pockets.

Spilled liquids can damage the upholstery, carpeting, and electrical components in the interior.

On vehicles with rear seat armrest

On vehicles with rear seat armrest

The rear seat also has a beverage holder in the center armrest. To use it, pivot the armrest down.

READ NEXT:

 Center Table

On LX and EX models To use the center table, pull up the outside edge of the table until it latches. To store it, pull the lever and lower the table. Sitting on or getting under the ta

 Lower Glove Box

Open the lower glove box by pulling the bottom of the handle. Close it with a firm push. Lock or unlock the glove box with the master key. The glove box light comes on when the parking li

 Upper Glove Box

Open the upper glove box by pushing up the lever. Close it by pulling down on the edge under the lever.

SEE MORE:

 VSA (Vehicle Stability Assist) System Components

Component Location Index VSA MODULATOR-CONTROL UNIT Removal and Installation UNDER-HOOD FUSE/RELAY BOX DATA LINK CONNECTOR (DLC) STEERING ANGLE SENSOR Replacement VSA OFF SWITCH Test RIGHT-REAR WHEEL SENSOR Replacement HUB BEARING UNIT (MAGNETIC ENCODER) Replace

 Accessory Power Sockets

Your vehicle has two or three accessory power sockets depending on the model. To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position. Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or l

© 2016-2026 Copyright www.hcrv.net