Honda CR-V: Glass
Honda CR-V (2006–2011) Service Manual / Body / Glass
Component Location Index
- WINDSHIELD MOLDING
- MOLDING UPPER SEAL
- UPPER RUBBER DAM
- CLIP, 2
- WINDSHIELD SIDE TRIM
- SIDE RUBBER DAM
- WINDSHIELD
- RETAINER,8
- QUARTER GLASS MOLDING
- CLIP, 1
- CLIP, 2
- QUARTER GLASS
- ULEV STICKER
- FRONT SEAL
- UPPER RUBBER DAM
- UPPER FASTENER 2
- FASTENER 2
- LOWER FASTENER 2
- LOWER RUBBER DAM
- 4 WD STICKER
- REAR WINDOW
READ NEXT:
Windshield Replacement
NOTE:
Put on gloves to protect your hands.
Wear eye protection when removing the glass with
piano wire.
Use seat covers to avoid damaging the seat.
When replacing a broken windshield, a commerci
Rear Window Replacement
NOTE:
Put on gloves to protect your hands.
Wear eye protection when removing the glass with
piano wire.
Use seat covers to avoid damaging any surfaces.
Do not damage the rear window defogger gri
Quarter Glass Replacement
NOTE:
Put on gloves to protect your hands.
Wear eye protection when removing the glass with
piano wire.
Use seat covers to avoid damaging any surfaces.
The quarter glass molding will need replac
SEE MORE:
Door Lower Trim Replacement
NOTE:
Take care not to scratch the door.
Put on gloves to protect your hands.
1. Remove these items:
Door panel, front , rear.
Door speaker, front, rear.
2. From the front or the rear door, remove the screw.
3. Using a utility knife, carefully cut the double-sided
adhesive tape (A) along th
Brake Pedal Position Switch Signal Circuit Troubleshooting
1. Turn the ignition switch ON (II).
2. Check the BRAKE SWITCH in the DATA LIST with
the HDS.
Does it indicate OFF?
YES-Go to step 3.
NO-Inspect the brake pedal position switch.
3. Press the brake pedal, and check the BRAKE
SWITCH in the DATA LIST with the HDS.
Does it change to ON? YES-The bra
© 2016-2026 Copyright www.hcrv.net
