Honda CR-V: Component Replacement/Inspection After Deployment

Honda CR-V (2006–2011) Service Manual / Restraints / SRS (Supplemental Restraint System) / Component Replacement/Inspection After Deployment

NOTE:

After a collision where the seat belt tensioners deployed, replace these items:"

After a collision where the front airbag(s) deployed, replace these items:

After a collision where the side airbag(s) deployed, replace these items:

After a collision1where the side curtain airbag(s).

deployed, replace these items:

After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace components as needed.

A-pillar trim

Honda CR-V. SRS (Supplemental Restraint System)

B-pillar trim

Honda CR-V. SRS (Supplemental Restraint System)

C-Pillar trim

Honda CR-V. SRS (Supplemental Restraint System)

During the repair process, inspect these areas:

After the vehicle is completely repaired, turn the ignition switch ON (II). If the SRS indicator comes on for about 6 seconds and then goes off, the SRS is OK. If the indicator does not function properly, use the HDS SRS Menu Method to read the DTC. If you cannot retrieve a code, go to SRS Symptom Troubleshooting.

Checking and Adjusting the Headliner/Piliar Trim Overlap

To prevent the side curtain airbag from deploying and damaging the pillar trim, the overlap between the headliner and pillar trim must be less then 0.3 in.

(8 mm). To check the overlap, do this: 1. Install the headliner (A) and the pillar trim (B).

Honda CR-V. SRS (Supplemental Restraint System)

2. Using masking tape on the headliner, mark the upper edge of each pillar trim.

Honda CR-V. SRS (Supplemental Restraint System)

3. Remove the pillar trim, and measure the headliner overlap.

Honda CR-V. SRS (Supplemental Restraint System)

4. Carefully trim the headliner with a utility knife, reducing the overlap to less than 0.3 in. (8 mm).

Honda CR-V. SRS (Supplemental Restraint System)

5. Remove the tape, and install the pillar trim.

READ NEXT:

 Driver's Airbag Replacement

Removal 1. Disconnect the negative cable from the battery and wait at least 3 minutes before beginning work. 2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airba

 Front Passenger's Airbag Replacement

Removal 1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. 2. Remove the passenger's vent panel. 3. Remove the dashboard center upper panel. 4. Re

 Side Airbag Replacement

NOTE: Review the seat replacement procedure before doing repairs or service. Removal 1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. 2. Disconnec

SEE MORE:

 To Play an iPod

This audio system can select and play the audio files on the iPod with the same controls used for the indash disc player. To play an iPod, connect it to the USB adapter cable in the upper glove box by using your dock connector. Press the AUDIO button beside the screen to show the aud

 Emergency Towing

If your vehicle needs to be towed, call a professional towing service or organization. Never tow your vehicle with just a rope or chain. It is very dangerous. On 4WD models The only way you can safely tow your vehicle is with flat-bed equipment. The operator will load Any other metho

© 2016-2026 Copyright www.hcrv.net