Honda CR-V: Seat Heaters

If equipped

If equipped

Both front seats are equipped with seat heaters. The passenger seat only has heaters in the seat bottom because of the side airbag cutoff system.

The ignition switch must be in the

The ignition switch must be in the ON (II) position to use the heaters.

Push the top of the switch, HI, to rapidly heat up the seat. After the seat reaches a comfortable temperature, select LO by pushing the bottom of the switch. This will keep the seat warm.

In the HI setting, the heater turns off when the seat gets warm, and turns back on after the seat’s temperature drops.

In the LO setting, the heater runs continuously. It does not cycle with temperature changes.

Follow these precautions when using the seat heaters:

Use the HI setting only to heat the seats quickly, because it draws large amounts of current from the battery.

If the engine is left idling for an extended period, do not use the seat heaters, even on the LO setting. It can weaken the battery, causing hard starting.

READ NEXT:

 Power Windows

Turn the ignition switch to the ON (II) position to raise or lower any window. To open the window, push the switch down and hold it. Release the switch when you want to stop the window.

 Moonroof

If equipped The moonroof can be tilted up in the back for ventilation, or it can be slid back into the roof. Use the switch on the front ceiling to operate the moonroof. You must turn the

 Mirrors

Keep the inside and outside mirrors clean and adjusted for best visibility. Be sure to adjust the mirrors before you start driving. The inside mirror has day and night positions. The night

SEE MORE:

 Exterior Lights

Component Location Index DAYTIME RUNNING LIGHTS CIRCUIT HEADLIGHTS FRONT SIDE MARKER/PARKING/ TURN SIGNAL LIGHTS HIGH MOUNT BRAKE LIGHT LICENSE PLATE LIGHT TAILLIGHT and BRAKE LIGHT REAR TURN SIGNAL LIGHT BACK-UP LIGHT LIGHTS-ON INDICATOR HIGH BEAM INDICATOR DRL INDICATOR COMB

 To Select a Station

You can use any of five methods to find radio stations on the selected band: tune, seek, scan, the preset buttons, and auto select. TUNE - Use the TUNE knob to tune the radio to a desired frequency. Turn the knob to the right to tune to a higher frequency, and turn it to the left to tu

© 2016-2025 Copyright www.hcrv.net