Honda CR-V: Reporting Safety Defects (U.S. Vehicles)

Honda CR-V (2006–2011) Owner's Manual / Warranty and Customer Relations / Reporting Safety Defects (U.S. Vehicles)

If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying American Honda Motor Co., Inc.

If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign.

However, NHTSA cannot become involved in individual problems between you, your dealer, or American Honda Motor Co., Inc.

To contact NHTSA, you may call the Vehicle Safety Hotline toll-free at 1-888-327-4236БЮ (TTY: 1-800-424-9153); go to http://www.saf ercar.gov; or write to:
Administrator, NHTSA, 1200 New Jersey Avenue, SE., Washington, DC 20590.

You can also obtain other information about motor vehicle safety from http://www.saf ercar.gov.

READ NEXT:

 AuthorizedManuals

Purchasing Factory Authorized Manuals (U.S. only) The publications shown below can be purchased from Helm Incorporated. You can order by phone or online: - Call Helm Inc. at 1-800-782-4356 (credit

 Honda CR-V (2006–2011) Service Manual

 Introduction

How to Use This Manual This manual is divided into multiple sections. The first page of each section is marked with a black tab that lines up with its corresponding thumb index tab on this page and th

SEE MORE:

 Cylinder Head

Special Tools Air Pressure Regulator Valve Guide Reamer, 5.5 mm Socket, 19 mm Holder Handle Adjuster Locknut Wrench Stem Seal Driver VTEC Air Adapter VTEC Air Stopper Air Joint Adapter Crankshaft Pulley Holder Valve Guide Driver, 5.5 mm Attachment, 52 x 55 mm Driver Valve Spring Co

 Side Engine Mount Bracket Replacement

1. Support the engine with a jack and wood block under the oil pan. 2. Remove the upper torque rod. 3. Remove the ground cable (A), then remove the side engine mount bracket (B). 4. Install the side engine mount bracket, then loosely tighten the new bolt and nut (C), and loosely tighten the bolt

© 2016-2025 Copyright www.hcrv.net