Honda CR-V: Loading CDs in the Changer

Your vehicle has the CD changer in the center console.

CD-R, CD-RWdisc, and CD compressed inMP3 andWMA will not work in this unit. Video CDs and DVD discs also will not work.

Do not spill any liquids on the center console. Spilled liquids can damage electrical components in the CD changer.

1. Open the center console cover,

1. Open the center console cover, then slide open the CD changer cover by pulling it rearward.

2. Push the EJECT button to remove

2. Push the EJECT button to remove the CD magazine. The magazine will pop up automatically.

3. To install a CD into the magazine,

3. To install a CD into the magazine, push the button while pulling out on the tab.

4. Put a CDon the tray with the printed surface facing up as shown.

5. Reinstall the tray in the magazine.

Repeat this procedure to open the other five trays.

6. Store all six trays in the magazine,

6. Store all six trays in the magazine, and reinstall the magazine in the CD changer as shown.

7. Make sure to slide the CD changer cover closed until it clicks.

To remove CDs from the CD changer, refer to the loading procedure.

READ NEXT:

 To Play a CD

To play CDs, the ignition switch must be in the ACCESSORY (I) or ON (II) position. You operate the CD changer with the same controls used for the indash disc player or the radio. To select

 To Stop Playing a CD

Press the AM/FMor CD/XM button to switch to the radio or satellite radio while a CD is playing. If there is a PC card in the audio unit, touch the CARD icon to switch to the PC card while a C

 CD Changer Error Messages (EX-L model with navigation system)

If you see an error message in the display while playing a disc, find the cause in the chart to the right. If you cannot clear the error message, take your vehicle to your dealer. The cha

SEE MORE:

 Transmission End Cover

End Cover Removal Special Tools Required Mainshaft holder 07GAB-PF50101 or 07GAB-PF50100 NOTE: The illustration shows the 4WD transmission; the 2WD is similar. 1. Remove the cooler inlet line bolt (D), sealing washers, and line bracket bolts (E), and remove the ATF cooler inlet line (F). 2. Remove

 Malfunction Indicator Lamp

If the indicator comes on while driving, it means one of the engine’s emissions control systems may have a problem. Even though you may feel no difference in your vehicle’s performance, it can reduce your fuel economy and cause increased emissions. Continued operation may cause

© 2016-2025 Copyright www.hcrv.net