Honda CR-V: Fan Controls

Component Location Index

Honda CR-V. Fan Controls

Symptom Troubleshooting Index

Honda CR-V. Fan Controls

Circuit Diagram

Honda CR-V. Fan Controls

Radiator Fan High Speed Circuit Troubleshooting

1. Remove the fan control relay from the under-hood fuse/relay box, and test it.

Is the relay OK?

YES-Go to step 2.

NO-Replace the fan control relay.

2. Measure the voltage between the fan control relay 5P socket terminal No. 5 and body ground.

Is there battery voltage? YES-Go to step 3.

NO-Replace the under-hood fuse/relay box.

3. Check for continuity between the fan control relay 5P socket terminal No.2 and body ground.

Is there continuity? YES-Replace the under-hood fuse/relay box.

NO-Repair open in the wire between the fan control relay 5P socket terminal No.2 and body ground. If the wire is OK, check for poor ground at G301.

READ NEXT:

 Fuel and Emissions

 Fuel and Emissions Systems

Special Tools Fuel Sender Wrench Fuel Pressure Gauge Attachment Set Vacuum/Pressure Gauge, 0-4 in.Hg Pressure Gauge Adapter Oil Pressure Hose A/T Pressure Hose A/T Low Pressure

 General Troubleshooting Information

Intermittent Failures The term "intermittent failure" means a system may have had a failure, but it checks OK now. If the malfunction indicator lamp (MIL) on the dash does not come on, check for poor

SEE MORE:

 Load Limits

Total Trailer Weight: The maximum allowable weight of the trailer and everything in or on it must not exceed 1,500 lbs (680 kg). Towing a load that is too heavy can seriously affect your vehicle’s handling and performance. It can also damage the engine and drivetrain. Tongue Lo

 Oil Pan Installation

1. Remove all of the old liquid gasket from the oil pan mating surfaces, bolts, and bolt holes. 2. Clean and dry the oil pan mating surfaces. 3. Apply liquid gasket, P/N 08717-0004,08718-0001, 08718-0003, or 08718-0009, evenly to the engine block mating surface of the oil pan and to the inner thre

© 2016-2025 Copyright www.hcrv.net