Honda CR-V manuals

Honda CR-V: Daytime Running Lights

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Daytime Running Lights

With the headlight switch in the off or the high beam position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II) position and release the parking brake. They remain on until you turn the ignition switch off, even if you set the parking brake.

The headlights revert to normal operation when you turn them on with the switch.

READ NEXT:

 Instrument Panel Brightness

You can change the instrument panel brightness only when the light switch is on. Turn the knob on the lower part of the instrument panel to adjust the brightness. You will hear a beep wh

 HazardWarning Button

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel t

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

SEE MORE:

 Fan Controls

Component Location Index RADIATOR FAN RELAY A/C CONDENSER FAN RELAY FAN CONTROL RELAY A/C CONDENSER FAN ASSEMBLY RADIATOR FAN ASSEMBLY ENGINE COOLANT TEMPERATURE (ECT) SENSOR 1 ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2 Symptom Troubleshooting Index Circuit Diagram Radiato

 Door Lock

Door Lock Actuator Test Driver's Door and Left Rear Door 1. Remove the door panel. Front Rear 2. Disconnect the 10P connector (A) from the actuator (B). NOTE: The illustration shows the driver's door. 3. Check the actuator operation by connecting power and ground according to the table. To

© 2016-2025 Copyright www.hcrv.net