Honda CR-V: Automatic Seat Belt Tensioners

For added protection, the front seat
belts are equipped with automatic
seat belt tensioners. When activated,
the tensioners immediately tighten
the belts to help hold the driver and
a front passenger in position.
The tensioners are designed to
activate in any collision severe
enough to cause the front airbags to
deploy, or if a sensor detects your
vehicle is about to roll over.
The tensioners can also be activated
during a collision in which the front
airbags do not deploy. In this case, the
airbags would not be needed, but the
extra tension in the seat belt could
be helpful.
When the tensioners are activated,
the seat belts will remain tight until
they are unbuckled.
READ NEXT:
For safety, you should check the
condition of your seat belts regularly.
Pull each belt out fully, and look for
frays, cuts, burns, and wear. Check
that the latches work smoothly and
the belt
Airbag System Components
Your airbag system includes:
Two SRS (supplemental restraint
system) front airbags. The driver’s
airbag is stored in the center of
the steering wheel; the fr
SEE MORE:
NOTE: Do not install an A/C compressor into a system
unless you are completely sure that the system is free
of contamination. Installing the A/C compressor into a
contaminated system can result in premature A/C
compressor failure.
1. If the A/C compressor is marginally operable, run
the engine at i
SRS Components
Airbags
The SRS is a safety device which, when used with the seat belt, is designed
to help protect the driver and front
passenger in a frontal impact exceeding a certain set limit. The system consists
of the SRS unit, including safing
sensor and impact sensor (A), the cable reel (B
© 2016-2025 Copyright www.hcrv.net
