Honda CR-V: WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

READ NEXT:

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

 Daytime Running Lights

With the headlight switch in the off or position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II)

SEE MORE:

 TPMS (Tire Pressure Monitoring System)

Component Location Index TPMS CONTROL UNIT (Behind the dashboard center lower cover) Replacement TIRE PRESSURE SENSOR Replacement TIRE PRESSURE SENSOR Replacement UNDER-DASH FUSE/RELAY BOX TIRE PRESSURE SENSOR Replacement DATA LINK CONNECTOR (DLC) TIRE PRESSURE SENS

 Frame

Under-cowl Panel Replacement NOTE: Take care not to scratch the body. 1. Remove these items: Windshield wiper arms Front fender trim, both sides Cowl covers 2. Remove the bolts and nuts, disconnect the connector (A) and remove the grommet (B), then remove the under-cowl panel (C). 3. Install

© 2016-2025 Copyright www.hcrv.net