Honda CR-V: To Stop Playing a Disc

To play the radio when a disc is playing, press the AM/FM button or touch the FM1, FM2, AM, XM1, or XM2 icon. If a PC card is in the audio unit, touch the CARD icon to play the PC card. If a CD or CDs are loaded in the CD changer, touch the CDC icon to play the CD changer.

Press the CD button again or touch the CD icon to switch back to the disc player.

If you turn the system off while a disc is playing, either with the power/volume knob or by turning off the ignition switch, the disc will stay in the drive.When you turn the system back on, the disc will begin playing where it left off.

READ NEXT:

 Removing a Disc

To remove a disc from the audio unit, fold back the screen by pressing the OPEN button. Press the disc eject button ( ) to remove the disc. If you eject the disc, but do not remove it from

 Disc Player Error Messages (EX-L model with navigation system)

If you see an error message in the display while playing a disc, find the cause in the chart to the right. If you cannot clear the error message, take your vehicle to your dealer. The cha

 CD Changer (EX-L model with navigation system)

CD Changer (EX-L model with navigation system)

SEE MORE:

 DTC 12, 14, 16, 18: Wheel Sensor (Electrical Noise/Intermittent Interruption)

NOTE: If the ABS and other indicators come on because of electrical noise, the indicators will go off when you test-drive the vehicle at 10 mph (15 km/h) or more and noise is gone. An incorrectly installed wheel bearing can cause one of these DTCs. 1. Turn the ignition switch OFF. 2. Check

 DTC Troubleshooting

DTC indicator 1: An Open in the Air Mix Control Motor Circuit 1. Start the engine. 2. Turn on the A/C, then set the temperature control dial to Max Hot. 3. Turn the ignition switch OFF and then ON (II). 4. Do the self-diagnostic with the HVAC control unit. 5. Check for DTCs. Is DTC 1 indicated?

© 2016-2025 Copyright www.hcrv.net