Honda CR-V: Automatic Seat Belt Tensioners
Honda CR-V (2006–2011) Owner's Manual / Driver and Passenger Safety / Additional Information About Your Seat Belts / Automatic Seat Belt Tensioners
For added protection, the front seat belts are equipped with automatic seat belt tensioners. When activated, the tensioners immediately tighten the belts to help hold the driver and a front passenger in position.
The tensioners are designed to activate in any collision severe enough to cause the front airbags to deploy, or if a sensor detects your vehicle is about to roll over.
The tensioners can also be activated during a collision in which the front airbags do not deploy. In this case, the airbags would not be needed, but the extra tension in the seat belt could be helpful.
When the tensioners are activated, the seat belts will remain tight until they are unbuckled.
READ NEXT:
Seat Belt Maintenance
For safety, you should check the
condition of your seat belts regularly.
Pull each belt out fully, and look for
frays, cuts, burns, and wear. Check
that the latches work smoothly and
the belt
Airbag System Components
Airbag System Components
Your airbag system includes:
Two SRS (supplemental restraint
system) front airbags. The driver’s
airbag is stored in the center of
the steering wheel; the fr
SEE MORE:
Overview of Contents
Contents
A convenient reference to the
sections in this manual.
Your Vehicle at a Glance
A quick reference to the main
controls in your vehicle.
Driver and Passenger Safety
Important information about the
proper use and care of your vehicle’s
seat belts, an overview of the
supplemen
Driver's Airbag Replacement
Removal
1. Disconnect the negative cable from the battery and
wait at least 3 minutes before beginning work.
2. Remove the access panel (A) from the steering
wheel, then disconnect the driver's airbag 4P
connector (B) and horn switch 1P connector (C)
from the cable reel.
3. Using a TORX T30 bit, r
© 2016-2025 Copyright www.hcrv.net
