Honda CR-V: Fuel Fill Door

Fuel Fill Door Adjustment

1. Remove the nut (A), then remove the open spring (B).

Honda CR-V. Fuel Fill Door

2. Slightly loosen the hinge mounting bolts (A).

Honda CR-V. Fuel Fill Door

3. Adjust the fuel fill door (B) in or out until it's flush with the body, and up or down as necessary to equalize the gaps.

4. Tighten the hinge mounting bolts.

5. Check that the fuel fill door opens properly and locks securely, and check that the rear of the door is flush with the body.

6. Reinstall the open spring and nut.

7. Apply multipurpose grease to each location indicated by the arrows.

Honda CR-V. Fuel Fill Door

8. Apply touch-up paint to the hinge mounting bolts and around the hinges.

Fuel Cap Adapter Replacement

NOTE: Take care not to scratch the body.

1. Remove the fuel pipe protector.

2. Remove the cap (A) by turning it counterclockwise.

Honda CR-V. Fuel Fill Door

3. From under the body, push out the hooks (A). Then turn the fuel cap adapter (B), and remove it from the fuel pipe.

Honda CR-V. Fuel Fill Door

4. Install the adapter in the reverse order of removal.

READ NEXT:

 Exterior Trim

 Upper/Lower Front Grille Replacement

Upper Front Grille Replacement NOTE: Take care not to scratch the bumper and grille. 1. Remove the front bumper. 2. Remove the clips from the back of the front grille and release the hooks (A), then

 Cowl Cover Replacement

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Take care not t

SEE MORE:

 Maintain a Proper Sitting Position

After all occupants have adjusted their seats and head restraints, and put on their seat belts, it is very important that they continue to sit upright, well back in their seats, with their feet on the floor, until the vehicle is safely parked and the engine is off. Sitting improperly

 Symptom Troubleshooting

Hard Steering 1. Check the power assist. Is the initial turning load more than 34 N (3.5 kgf, 7.7 Ibf) ? YES-Go to step 2. NO-Power assist is OK. 2. Connect the P/S joint adapter (pump), P/S joint adapter (hose), and P/S pressure gauge T/N 07406- 0010001 (see page 17-9), T/N 07406-001000A or T/N

© 2016-2025 Copyright www.hcrv.net