Honda CR-V: Driver's Airbag Replacement
Removal
1. Disconnect the negative cable from the battery and
wait at least 3 minutes before beginning work.
2. Remove the access panel (A) from the steering
wheel, then disconnect the driver's airbag 4P
connector (B) and horn switch 1P connector (C)
from the cable reel.

3. Using a TORX T30 bit, remove the two TORX bolts
(A).

4. Remove the driver's airbag (B).
Installation
1. Connect the horn switch connector (1P) (A) to the
driver's airbag (B).

2. Place the driver's airbag in the steering wheel, and
secure it with new TORX bolts (C).
3. Connect the cable reel 4P connector (A) to the
driver's airbag 4P connector, then install the access
panel (B) on the steering wheel.

4. Connect the negative cable from the battery.
5. After installing the airbag, confirm proper system
operation:
- Turn the ignition switch ON (II); the SRS indicator should come on for
about 6 seconds and then go off.
- Make sure the horn works.
READ NEXT:
Removal
1. Disconnect the negative cable from the battery, and
wait at least 3 minutes before beginning work.
2. Remove the passenger's vent panel.
3. Remove the dashboard center upper panel.
4. Re
NOTE: Review the seat replacement procedure before doing repairs or service.
Removal
1. Disconnect the negative cable from the battery, and
wait at least 3 minutes before beginning work.
2. Disconnec
Special Tools Required
Deployment tool 07HAZ-SG00500
Before scrapping any airbags, side airbags, side curtain
airbags, seat belt tensioners; or lap belt tensioner
(including those in a whole vehicle t
SEE MORE:
Special Tools
07HAE-PL50101 may also be used to substitute one of 07LAE-PX40100.
Mainshaft Holder
Attachment, 78 x 90 mm
Clutch Spring Compressor Bolt Assembly
Holder Handle
Oil Seal Driver Attachment
Attachment, 40 x 50 mm
Clutch spring Compressor Attachment
Bearing Installer Attachment
Use the compact spare tire as a
temporary replacement only. Get
your regular tire repaired or replaced,
and put it back on your vehicle as
soon as you can.
Check the air pressure of the
compact spare tire every time you
check the other tires. It should be
inflated to:
60 psi (420 kPa
© 2016-2025 Copyright www.hcrv.net
