Honda CR-V: Security System

If equipped

The security system helps to protect your vehicle and valuables from theft.

The horn sounds and a combination of headlights, parking lights, side marker lights and taillights flash if someone attempts to break into your vehicle or remove the audio unit.

This alarm continues for 2 minutes, then the system resets. To reset an activated system before the 2 minutes have elapsed, unlock the driver’s door with the key or use the remote transmitter.

The security system automatically sets 15 seconds after you lock the doors, hood, and the tailgate. For the system to activate, you must lock the doors and the tailgate fromthe outside with the key, driver’s lock tab, door lock master switch, or remote transmitter. The security system indicator on the instrument panel starts blinking immediately to show you the system is setting itself.

Once the security system is set,

Once the security system is set, opening any door without using the key or the remote transmitter, the hood, or the tailgate will cause the system to alarm.

The security system will not set if the hood, tailgate, or any of the doors are not fully closed. If the system will not set, check the doors and the tailgate. You can also check the open indicator on the instrument panel, to see if the doors and the tailgate are fully closed. Since it is not part of the monitor display, manually check the hood.

NOTE: Use the remote transmitter to quickly check that the hood, the tailgate, and all doors are closed.

Push the lock button twice within 5 seconds. There should be an audible confirmation beep.

Do not attempt to alter this system or add other devices to it.

READ NEXT:

 Rearview Camera and Monitor

On EX-L model with navigation system Whenever you shift to reverse (R) with the ignition switch in the ON (II) position, the rearview is shown on the navigation system screen. For the best p

 Cruise Control

Cruise control allows you to maintain a set speed above 25 mph (40 km/h) without keeping your foot on the accelerator pedal. It should be used for cruising on straight, open highways. It is

 Using the Cruise Control

1. Push the CRUISE button on the steering wheel. The CRUISE MAIN indicator on the instrument panel comes on. The cruise control systemcan be left on, even when it is not in use. 2. Acceler

SEE MORE:

 Transfer Assembly Inspection/Removal/Installation

Transfer Assembly Inspection 1. Shift the transmission into the N position. 2. Raise the vehicle on a lift, and make sure it is supported securely. 3. Make a reference mark (A) across the propeller shaft (B) and the transfer companion flange (C). 4. Separate the propeller shaft from the transfer

 Replacing a Front Turn Signal Light Bulb

1. Open the hood. To change the turn signal bulb on the driver’s side, remove the engine coolant reserve tank by pulling it out of its holder. 2. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise. 3. Pull the bulb straight out of its s

© 2016-2025 Copyright www.hcrv.net