Honda CR-V: Rear Window Wiper and Washer
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Windshield Wipers and Washers / Rear Window Wiper and Washer
1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position.
2. Rotate the switch clockwise to turn the rear window wiper ON.
The wiper operates every 7 seconds after completing two sweeps.
3. Hold past ON to activate the rear window wiper a few times and to spray the rear window washer.
4. Rotate the switch counterclockwise also to spray the window washer and turn the wiper on.
When you shift the transmission to the reverse position with the front windshield wiper activated, the rear wiper operates automatically even if the rear wiper switch is off.
The rear window washer uses the same fluid reservoir as the windshield washer.
READ NEXT:
Turn Signal and Headlights
1. Turn Signal
2. OFF
3. Parking and interior lights
4. AUTO
5. Headlights on
6. High Beams
7. Flash high beams
*: If equipped
Turn Signal - Push down on the
lever to signal a left turn
Daytime Running Lights
With the headlight switch in the off
or
position,
the high beam
headlights and the high beam
indicator come on with reduced
brightness when you turn the
ignition switch to the ON (II)
Instrument Panel Brightness
You can change the instrument panel
brightness only when the light
switch is on.
Turn the knob on the lower part of
the instrument panel to adjust the
brightness.
You will hear a beep wh
SEE MORE:
Poor AM or FM radio reception or
interference (with navigation)
NOTE:
Check the radio reception in an open area.
Compare it to a known-good vehicle of the same
model, year, and trim level whenever possible.
If necessary, have the customer demonstrate the
symptom.
Poor reception/interference can be caused by the following.
The radio station is far away.
Intermediate Shaft
Intermediate Shaft Removal
1. Drain the automatic transmission fluid. Reinstall the drain plug with a
new washer.
2. Remove the right driveshaft.
3. Remove the flange bolt (A) and two dowel bolts (B).
4. Remove the intermediate shaft (A) from the
differential. Hold the intermediate shaft horizon
© 2016-2025 Copyright www.hcrv.net
