Honda CR-V: Disconnecting an iPod
Honda CR-V (2006–2011) Owner's Manual / Features / Playing an iPod (EX-L model with navigation system) / Disconnecting an iPod
You can disconnect the iPod at any time when you see ‘‘OK to disconnect’’ message* in the iPod display. Always make sure you see ‘‘OK to disconnect’’ message in the iPod display before you disconnect it.
Make sure to follow the iPod’s instructions on how to disconnect the dock connector from the USB adapter cable.
*: The displayed message may vary on models or versions. On some models, there is no message to disconnect.
When you disconnect the iPod while it is playing, the navigation screen shows ‘‘NO DATA.’’
If you reconnect the same iPod, the system may begin playing where it left off, depending on what mode the iPod is in when it is reconnected.
READ NEXT:
iPod Error Messages
If you see an error message on the
screen while playing an iPod, find
the solution in the chart to the right.
If you cannot clear the error
message, take your vehicle to your
dealer.
Playing a USB Flash Memory Device (EX-L model with navigation system)
Playing a USB Flash Memory Device (EX-L model with navigation system)
To Play a USB Flash Memory Device
This audio system can select and
play the audio files from a USB flash
memory device with the same
controls used for the in-dash disc
player. To play a USB flash memory
device, connect it to
SEE MORE:
Front Driveshaft Disassembly
Special Tools Required
Threaded adapter, 26 x 1.5 mm 07XAC-001030A
Slide hammer, 5/8"-18 UNF, commercially available
Inboard Joint Side
1. Remove the set ring (A) from the inboard joint.
2. Remove the boot bands. Be careful not to damage the boot.
3. Make marks (A) on each roller (B) and inboa
DTC P2270/P2271: Secondary HO2S (Sensor 2)
Circuit Signal Stuck Lean/Rich
DTC P2270: Secondary HO2S (Sensor 2)
Circuit Signal Stuck Lean
DTC P2271: Secondary HO2S (Sensor 2)
Circuit Signal Stuck Rich
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2
© 2016-2025 Copyright www.hcrv.net
