Honda CR-V: Accessory Power Sockets

Your vehicle has two or three
accessory power sockets depending
on the model.

To use an accessory power socket,
the ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Each socket is intended to supply
power for 12 volt DC accessories
that are rated 120 watts or less (10
amps).

None of the sockets will power an
automotive type cigarette lighter
element.

Make sure to put the socket cover
back in place to prevent any small
foreign objects from getting into the
socket.
READ NEXT:
EX-L model
Push the release knob to open or
close the console compartment, slide
the lid rearward.
To use a coat hook, slide it out
slightly, then pull it down.
Make sure the coat hook is folded up
when you are not using it. This hook
is not designed for large or heavy
items.
If equipped
Your vehicle has a seat under tray
located under the front passenger
seat. Use the tray by pulling on the
front center edge of the tray.
SEE MORE:
1. With the ignition switch ON (II), push the power
switch ON to see if navigation unit turns ON.
Does the navigation unit display operate properly, and does the audio sound
normal? YES-Intermittent failure, the system is OK at this time.
NO-Go to step 2.
2. Turn the ignition switch OFF.
3. Che
Component Location Index
SRS INDICATOR
SIDE AIRBAG CUTOFF INDICATOR
MEMORY ERASE
SIGNAL (MES)
CONNECTOR (2P)
(YELLOW)
CABLE REEL
PASSENGER'S AIRBAG CUTOFF INDICATOR
FRONT PASSENGER'S AIRBAG
DRIVER'S AIRBAG
OPDS SENSOR/SEAT-BACK
FRONT PASSENGER'S
SIDE AIRBAG
RIGHT SIDE IMPACT SENSOR
© 2016-2026 Copyright www.hcrv.net
