Honda CR-V: Fan Controls
Component Location Index
- RADIATOR FAN RELAY
- A/C CONDENSER FAN RELAY
- FAN CONTROL RELAY
-
A/C CONDENSER FAN ASSEMBLY
-
RADIATOR FAN ASSEMBLY
-
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 1 -
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 2
Symptom Troubleshooting Index
Circuit Diagram
Radiator Fan High Speed Circuit Troubleshooting
1. Remove the fan control relay from the under-hood fuse/relay box, and test it.
Is the relay OK?
YES-Go to step 2.
NO-Replace the fan control relay.
2. Measure the voltage between the fan control relay 5P socket terminal No. 5 and body ground.
Is there battery voltage? YES-Go to step 3.
NO-Replace the under-hood fuse/relay box.
3. Check for continuity between the fan control relay 5P socket terminal No.2 and body ground.
Is there continuity? YES-Replace the under-hood fuse/relay box.
NO-Repair open in the wire between the fan control relay 5P socket terminal No.2 and body ground. If the wire is OK, check for poor ground at G301.
READ NEXT:
Fuel and Emissions Systems
Special Tools
Fuel Sender Wrench
Fuel Pressure Gauge Attachment Set
Vacuum/Pressure Gauge, 0-4 in.Hg
Pressure Gauge Adapter
Oil Pressure Hose
A/T Pressure Hose
A/T Low Pressure
General Troubleshooting Information
Intermittent Failures
The term "intermittent failure" means a system may
have had a failure, but it checks OK now. If the
malfunction indicator lamp (MIL) on the dash does not
come on, check for poor
SEE MORE:
DTC 86: F-CAN Communication
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch OFF.
4. Start the engine.
5. Wait at least 5 seconds.
6. Check for DTCs with the HDS.
Is DTC 86 indicated?
YES-Go to step 7.
NO-Intermittent failure, the system is OK at this time. Check for a loos
Engine Installation
Special Tools Required
Universal eyelet 07 AAK-SNAA 120
Engine hanger adapter VSB02C000015 *
Front subframe adapter VSB02C000016 *
CR-V engine hanger adapter VSB02C000032 *
Engine support hanger, A and Reds AAR-T-12566 *
* : Available through American Honda Tool and Equipment Program,
1-888-
