Honda CR-V: Dual Temperature Control

EX-L model only

EX-L model only

The temperatures of the driver’s side and the front passenger’s side can be controlled independently when the indicator in the DUAL button is on.

To adjust the driver’s side, turn the driver’s side temperature control dial on the climate control panel. To adjust the passenger’s side, turn the passenger’s side temperature control dial.

Temperature Control

Push AUTO or temperatures appear in the display.. The selected temperatures appear in the display.

When the indicator in the DUAL button is off, you can adjust both sides to the same temperature by adjusting the driver’s temperature control dial.

To set the driver’s side temperature

To set the driver’s side temperature to a different value than the passenger’s side, press the DUAL button, then turn the temperature control dial on the control panel. To set the passenger’s side to a different value than the driver’s side, turn the passenger’s side temperature control dial. You can adjust the passenger’s side without pressing the DUAL button first.

When you set the temperature to its lower limit or its upper limit, it will be displayed as ‘‘Lo’’ or ‘‘Hi’’.

READ NEXT:

 Climate Control Sensors

Sunlight and Temperature Sensors The climate control systemhas two sensors: a sunlight sensor on top of the dashboard, and a temperature and humidity sensor next to the steering column. D

 Audio System

An audio system is standard on all models. Read the appropriate pages (as shown below) to use your vehicle’s audio system. Audio System

 Playing the AM/FM Radio (LX model)

Playing the AM/FM Radio (LX model)

SEE MORE:

 If a Child Requires Close Attention

Many parents say they prefer to put an infant or a small child in the front passenger seat so they can watch the child, or because the child requires attention. Placing a child in the front seat exposes the child to hazards in a frontal collision, and paying close attention to a child

 DTC P1157: A/F Sensor (Sensor 1) AFS Circuit High Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Start the engine, and wait 1 minute. 4. Check for Temporary DTCs or DTCs with the HDS. Is DT

© 2016-2025 Copyright www.hcrv.net