Honda CR-V: Compass Zone Selection
In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone, do this:
1. Press and hold the select/reset
knob for 10 seconds to change the
display to the reset mode.

2. Select the zone indicator by
turning the select/reset knob. The
display begins to blink. Push the
same knob to enter this setting.
3. Find the zone for your area on the
zone map. Each
zone number (1 through 15)
corresponds to a compass zone.
4. Turn the select/reset knob to
select the appropriate zone
number, and press the select/
reset knob to enter the number.
When the system does not accept
the selected compass zone, you see
‘‘- -’’ in the direction display. Select
appropriate zone number again.

READ NEXT:
If equipped
The security system helps to protect
your vehicle and valuables from theft.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights flash
On EX-L model with navigation system
Whenever you shift to reverse (R)
with the ignition switch in the ON
(II) position, the rearview is shown
on the navigation system screen.
For the best p
Cruise control allows you to maintain
a set speed above 25 mph (40 km/h)
without keeping your foot on the
accelerator pedal. It should be used
for cruising on straight, open
highways. It is
SEE MORE:
Tires marked ‘‘M + S’’ or ‘‘All
Season’’ on the sidewall have an allweather
tread design suitable for
most winter driving conditions.
For the best performance in snowy
or icy conditions, you should install
snow tires or tire chains. They may
be required by local laws und
Open the lower glove box by pulling
the bottom of the handle. Close it
with a firm push. Lock or unlock the
glove box with the master key.
The glove box light comes on when
the parking lights are on.
An open glove box can cause
serious injury to your passenger
in a crash, even
© 2016-2025 Copyright www.hcrv.net
