Honda CR-V: Automatic Seat Belt Tensioners
Honda CR-V (2006–2011) Owner's Manual / Driver and Passenger Safety / Additional Information About Your Seat Belts / Automatic Seat Belt Tensioners
For added protection, the front seat belts are equipped with automatic seat belt tensioners. When activated, the tensioners immediately tighten the belts to help hold the driver and a front passenger in position.
The tensioners are designed to activate in any collision severe enough to cause the front airbags to deploy, or if a sensor detects your vehicle is about to roll over.
The tensioners can also be activated during a collision in which the front airbags do not deploy. In this case, the airbags would not be needed, but the extra tension in the seat belt could be helpful.
When the tensioners are activated, the seat belts will remain tight until they are unbuckled.
READ NEXT:
Seat Belt Maintenance
For safety, you should check the
condition of your seat belts regularly.
Pull each belt out fully, and look for
frays, cuts, burns, and wear. Check
that the latches work smoothly and
the belt
Airbag System Components
Airbag System Components
Your airbag system includes:
Two SRS (supplemental restraint
system) front airbags. The driver’s
airbag is stored in the center of
the steering wheel; the fr
SEE MORE:
Hydraulic Controls
Valve Bodies
The valve body includes the main valve body, the regulator valve body, and
the servo body. The ATF pump is driven
by splines on the left end of the torque converter which is attached to the
engine. Fluid flows through the regulator
valve to maintain specified pressure through the main
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Check TP SENSOR A in the DATA LIST with the
HDS.
Is there about 0.3 V or less?
YES-Go to ste
© 2016-2025 Copyright www.hcrv.net
