Honda CR-V: WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

READ NEXT:

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

 Daytime Running Lights

With the headlight switch in the off or position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II)

SEE MORE:

 Auto Door Locking

The auto door locking feature has three possible settings: The auto door locking is deactivated all the time. The doors and tailgate lock whenever you move the shift lever out of the Park (P) position. The doors and tailgate lock when the vehicle speed reaches 9 mph (15 km/h). This i

 Reminder Systems

Component Location Index GAUGE CONTROL MODULE MICU Circuit Diagram Control Unit Input Test NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. MICU 1. Turn the ignition switch OFF. 2. Remove the left kick panel. 3. Disconnect the under-dash fuse/relay box connectors.

© 2016-2025 Copyright www.hcrv.net