Honda CR-V: VSA OFF Switch

This switch is under the driver’s side

This switch is under the driver’s side vent. To turn the VSA system on and off, press and hold it until you hear a beep.

When VSA is off, the VSA off indicator comes on as a reminder.

Press and hold the switch again. It turns the system back on.

VSA is turned on every time you start the engine, even if you turned it off the last time you drove the vehicle.

In certain unusual conditions when your vehicle gets stuck in shallow mud or fresh snow, it may be easier to free it with the VSA temporarily switched off. When the VSA system is off, the traction control system is also off. You should only attempt to free your vehicle with the VSA off if you are not able to free it when the VSA is on.

Immediately after freeing your vehicle, be sure to switch the VSA on again. We do not recommend driving your vehicle with the VSA and traction control systems switched off.

READ NEXT:

 VSA and Tire Sizes

Driving with varying tire or wheel sizes may cause the VSA to malfunction. When replacing tires, make sure they are the same size and type as your original tires. If you install winter tires,

 Tire Pressure Monitoring System (TPMS)

Your vehicle is equipped with a tire pressure monitoring system (TPMS) that turns on every time you start the engine and monitors the pressure in your tires while driving. Each tire has its o

 Changing a Tire with TPMS

If you have a flat tire, the low tire pressure indicator will come on. Replace the flat tire with the compact spare tire. Each wheel (except the compact spare tire wheel) is equippedwith a t

SEE MORE:

 Information Display

The information display consists of three segments. The upper segment displays current fuel mileage, the second segment displays the odometer, average fuel mileage, range (estimated distance), engine oil life, and the lower segment displays the trip meter, and maintenance item co

 XM radio display is blank and no station information is displayed

1. Disconnect audio disc changer 13P connector. 2. Turn the ignition switch to ACC (I). 3. Operate the XM radio, and check the display. Is XM information displayed? YES-Replace the audio disc changer. NO-Go to step 4. 4. Check the No. 34 (7.5 A) fuse in the under-dash fuse/relay box and the No.

© 2016-2025 Copyright www.hcrv.net