Honda CR-V: Check Out Your Vehicle

Before you leave the pavement, be sure to do all scheduled maintenance and service, and inspect your vehicle for any problems. Pay special attention to the condition of the tires, and check the tire pressures.

After you return to the pavement, carefully inspect your vehicle to make sure there is no damage that could make driving it unsafe.

Recheck the condition of the tires and the tire pressures.

READ NEXT:

 Remember

The route presents limits (too steep or bumpy roads). You have limits (driving skill and comfort). And your vehicle has limits (traction, stability, and power). Driving off-highway can be h

 Accelerating and Braking

For better traction on all surfaces, accelerate slowly and gradually build up speed. If you try to start too fast on wet soil, mud, snow, or ice, you might not have enough traction to get un

 Avoiding Obstacles

Debris in the road can damage your suspension or other components. Because your vehicle has a high center of gravity, driving over a large obstacle, or allowing a wheel to drop into a deep ho

SEE MORE:

 Troubleshooting

Troubleshooting - B-CAN System Diagnosis Test Mode A Check the PCM for DTCs, and troubleshoot PCM or F-CAN loss of communication errors first, then do this diagnosis if the symptom is related to the B-CAN system. NOTE: Always cycle the ignition switch within 3 seconds when prompted in the DTC troub

 Piston, Pin, and Connecting Rod Replacement

Disassembly 1. Remove the piston from the engine block. 2. Apply new engine oil to the piston pin snap rings (A), and turn them in the ring grooves until the end gaps are lined up with the cutouts in the piston pin bores (B). NOTE: Take care not to damage the ring grooves. 3. Remove both snap rin

© 2016-2025 Copyright www.hcrv.net