Honda CR-V: Removing Discs from the In-dash Disc Changer

Honda CR-V (2006–2011) Owner's Manual / Features / Playing Discs (EX and EX-L models without navigation system) / Removing Discs from the In-dash Disc Changer

To remove the disc currently in play, press the eject button. When a disc is removed from a slot, the system automatically begins the load sequence so you can load another disc in that position. If you do not remove the disc from the changer within 10 seconds, the disc will reload into the slot. Then the system returns to the previous mode (AM, FM, or XM Radio*).

*: On U.S. EX-L model

To remove a different disc from the changer, first select it with the appropriate preset button. When that disc begins playing, press the eject button. Continue pressing the eject button to remove all the discs from the changer.

You can also eject discs when the ignition switch is off. The disc that was last selected is ejected first.

SEE MORE:

DTC P0101: MAF Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P1128, P1129, P2228, and/or P2229 are stored at the same time as DTC P0101, troubleshoot those DTCs first, then recheck for DTC P0101. 1. Check for poor

Shifting

To shift from any position, press firmly on the brake pedal and the release button on the side of the shift lever. You cannot shift out of Park when the ignition switch is in the LOCK (0) or ACCESSORY (I) position. Park (P) - This position mechanically locks the transmission. Use

Honda CR-V: Removing Discs from the In-dash Disc Changer

READ NEXT:

Disc Player Error Messages (EX and EX-L models without navigation system)

Playing an iPod (Canadian EX model and EX-L model without navigation system)

To Play an iPod

SEE MORE:

DTC P0101: MAF Sensor Range/Performance Problem

Shifting