Honda CR-V manuals

Honda CR-V: Instrument Panel Brightness

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Instrument Panel Brightness

You can change the instrument panel

You can change the instrument panel brightness only when the light switch is on.

Turn the knob on the lower part of the instrument panel to adjust the brightness.

You will hear a beep when maximum or minimum brightness is reached.

To reduce glare at night, the

To reduce glare at night, the instrument panel illumination dims when you turn the light switch to Turning the select/ or Turning the select/. Turning the select/ reset knob fully to the right until you hear a beep will cancel the reduced brightness.

READ NEXT:

 HazardWarning Button

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel t

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

 Parking Brake

To apply the parking brake, push the pedal down with your foot. To release it, push on the pedal again. The parking brake indicator on the instrument panel should go out when the parking

SEE MORE:

 Operating the XM Radio

To listen to XM Radio, turn the ignition switch to the ACCESSORY (I) or the ON (II) position. Push the power/volume knob to turn on the audio system, and press the CD/XM button. Adjust the volume by turning the knob. The last channel you listened to will show in the display. You can a

 DTC Troubleshooting

DTC P0506: Idle Control System RPM Lower Than Expected NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Start the engine. Hold the engine speed

© 2016-2025 Copyright www.hcrv.net