Honda CR-V: Fan Controls

Component Location Index

Honda CR-V. Fan Controls

Symptom Troubleshooting Index

Honda CR-V. Fan Controls

Circuit Diagram

Honda CR-V. Fan Controls

Radiator Fan High Speed Circuit Troubleshooting

1. Remove the fan control relay from the under-hood fuse/relay box, and test it.

Is the relay OK?

YES-Go to step 2.

NO-Replace the fan control relay.

2. Measure the voltage between the fan control relay 5P socket terminal No. 5 and body ground.

Is there battery voltage? YES-Go to step 3.

NO-Replace the under-hood fuse/relay box.

3. Check for continuity between the fan control relay 5P socket terminal No.2 and body ground.

Is there continuity? YES-Replace the under-hood fuse/relay box.

NO-Repair open in the wire between the fan control relay 5P socket terminal No.2 and body ground. If the wire is OK, check for poor ground at G301.

READ NEXT:

 Fuel and Emissions

 Fuel and Emissions Systems

Special Tools Fuel Sender Wrench Fuel Pressure Gauge Attachment Set Vacuum/Pressure Gauge, 0-4 in.Hg Pressure Gauge Adapter Oil Pressure Hose A/T Pressure Hose A/T Low Pressure

 General Troubleshooting Information

Intermittent Failures The term "intermittent failure" means a system may have had a failure, but it checks OK now. If the malfunction indicator lamp (MIL) on the dash does not come on, check for poor

SEE MORE:

 Starting System

Component Location Index STARTER CUT RELAY UNDER-DASH FUSE/RELAY BOX STARTER Starter Circuit Troubleshooting Performance Test Removal and Installation Overhaul TRANSMISSION RANGE SWITCH Test Replacement Symptom Troubleshooting Index Engine

 DTC P1157: A/F Sensor (Sensor 1) AFS Circuit High Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Start the engine, and wait 1 minute. 4. Check for Temporary DTCs or DTCs with the HDS. Is DT

© 2016-2026 Copyright www.hcrv.net