Honda CR-V: Front Passenger's Airbag Replacement
Removal
1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
2. Remove the passenger's vent panel.
3. Remove the dashboard center upper panel.
4. Remove the access panel (see step 5).
5. Detach the hook of the glove box damper and release the glove box stop on each side from the dashboard by pushing them inside (see step 1), then disconnect the front passenger's airbag 4P connector (A) from the dashboard wire harness.
6. Remove the three mounting nuts (A) from the bracket. Using only your hands, first lift the front edge of the airbag, then lift the left side, then lift the right side, and remove the front passenger's airbag (B) from the dashboard.
NOTE: The airbag lid has pawls (C) on each side which attach it to the dashboard.
Installation
1. Place the new front passenger's airbag (A) into the dashboard. Tighten the front passenger's airbag mounting nuts (B).
2. Connect the front passenger's airbag 4P connector (A) to dashboard wire harness, then reinstall the glove box.
3. Install the access panel (see step 5).
4. Install the dashboard center upper panel.
5. Install the passenger's vent panel.
6. Reconnect the negative cable to the battery.
7. After installing the airbag, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
READ NEXT:
Side Airbag Replacement
NOTE: Review the seat replacement procedure before doing repairs or service.
Removal
1. Disconnect the negative cable from the battery, and
wait at least 3 minutes before beginning work.
2. Disconnec
Airbag and Tensioner Disposal
Special Tools Required
Deployment tool 07HAZ-SG00500
Before scrapping any airbags, side airbags, side curtain
airbags, seat belt tensioners; or lap belt tensioner
(including those in a whole vehicle t
Cable Reel Replacement
Removal
1. Make sure the front wheels are aligned straight
ahead.
2. Disconnect the negative cable from the battery, and
wait at least 3 minutes.
3. Remove the driver's airbag.
4. Disconnect the co
SEE MORE:
Troubleshooting
Troubleshooting - B-CAN System
Diagnosis Test Mode A
Check the PCM for DTCs, and troubleshoot PCM or F-CAN loss of communication errors
first, then do this diagnosis if the symptom is related to
the B-CAN system.
NOTE: Always cycle the ignition switch within
3 seconds when prompted in the DTC troub
Using a Track List
You can also select a file directly
from a track list on the audio display.
Press the AUDIO button to show the
audio display, then touch the Track
List icon. The track list menu
appears on the display.
To scroll through the display, touch
the
or
icon on the side of the
scr
