Honda CR-V manuals

Honda CR-V: Instrument Panel Brightness

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Instrument Panel Brightness

You can change the instrument panel

You can change the instrument panel brightness only when the light switch is on.

Turn the knob on the lower part of the instrument panel to adjust the brightness.

You will hear a beep when maximum or minimum brightness is reached.

To reduce glare at night, the

To reduce glare at night, the instrument panel illumination dims when you turn the light switch to Turning the select/ or Turning the select/. Turning the select/ reset knob fully to the right until you hear a beep will cancel the reduced brightness.

READ NEXT:

 HazardWarning Button

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel t

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

 Parking Brake

To apply the parking brake, push the pedal down with your foot. To release it, push on the pedal again. The parking brake indicator on the instrument panel should go out when the parking

SEE MORE:

 Adding Engine Oil

Unscrew and remove the engine oil fill cap on top of the valve cover. Pour in the oil slowly and carefully you do not spill any. Clean up any spills immediately. Spilled oil could damage components in the engine compartment. Reinstall the engine oil fill cap, and tighten it securely.

 APP Sensor Signal Inspection

NOTE: This procedure checks the APP sensor in its fully closed position. In any other position, the APP sensor stores DTCs which are covered in other troubleshooting procedures. Check for Temporary DTCs or DTCs with the HDS before doing this procedure. If any DTCs are indicated, troubleshoot

© 2016-2025 Copyright www.hcrv.net