Honda CR-V: Driver's Airbag Replacement

Removal

1. Disconnect the negative cable from the battery and wait at least 3 minutes before beginning work.

2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) and horn switch 1P connector (C) from the cable reel.

Honda CR-V. SRS (Supplemental Restraint System)

3. Using a TORX T30 bit, remove the two TORX bolts (A).

Honda CR-V. SRS (Supplemental Restraint System)

4. Remove the driver's airbag (B).

Installation

1. Connect the horn switch connector (1P) (A) to the driver's airbag (B).

Honda CR-V. SRS (Supplemental Restraint System)

2. Place the driver's airbag in the steering wheel, and secure it with new TORX bolts (C).

3. Connect the cable reel 4P connector (A) to the driver's airbag 4P connector, then install the access panel (B) on the steering wheel.

Honda CR-V. SRS (Supplemental Restraint System)

4. Connect the negative cable from the battery.

5. After installing the airbag, confirm proper system operation:

READ NEXT:

 Front Passenger's Airbag Replacement

Removal 1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. 2. Remove the passenger's vent panel. 3. Remove the dashboard center upper panel. 4. Re

 Side Airbag Replacement

NOTE: Review the seat replacement procedure before doing repairs or service. Removal 1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. 2. Disconnec

 Airbag and Tensioner Disposal

Special Tools Required Deployment tool 07HAZ-SG00500 Before scrapping any airbags, side airbags, side curtain airbags, seat belt tensioners; or lap belt tensioner (including those in a whole vehicle t

SEE MORE:

 Towing a Trailer

Your vehicle has been designed primarily to carry passengers and their cargo. You can also use it to tow a trailer if you carefully observe the load limits, use the proper equipment, and follow the guidelines in this section. Break-In Period Avoid towing a trailer during your vehicle

 Cargo Pass-through

The rear center seat-back has a cargo area pass-through. To use the cargo area pass-through, pull up the release on top of the center seatback and fold it down. If your vehicle is equipped with a dual deck cargo shelf, do not use the shelf when any seat-back is folded down. Object

© 2016-2025 Copyright www.hcrv.net