Honda CR-V: Accessory Power Sockets

Your vehicle has two or three

Your vehicle has two or three accessory power sockets depending on the model.

To use an accessory power socket,

To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position.

Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or less (10 amps).

None of the sockets will power an

None of the sockets will power an automotive type cigarette lighter element.

Make sure to put the socket cover

Make sure to put the socket cover back in place to prevent any small foreign objects from getting into the socket.

READ NEXT:

 Console Compartment

EX-L model Push the release knob to open or close the console compartment, slide the lid rearward.

 Coat Hook

To use a coat hook, slide it out slightly, then pull it down. Make sure the coat hook is folded up when you are not using it. This hook is not designed for large or heavy items.

 Seat Under Tray

If equipped Your vehicle has a seat under tray located under the front passenger seat. Use the tray by pulling on the front center edge of the tray.

SEE MORE:

 Steering

Special Tools Piston Seal Ring Sizing Tool Bushing Base Piston Seal Ring Guide Cylinder End Seal Slide Locknut Wrench, 40 mm Ball Joint Remover, 28 mm Valve Seal Ring Sizing Tool Sleeve Seal Ring Guide Pulley Holder Sleeve Seal Ring Sizing Tool, 36 mm P/S Joint Adapter (pump) P/S Join

 Fuel Pump Circuit Troubleshooting

If you suspect a problem with the fuel pump, check that the fuel pump actually runs; when it is on, you will hear some noise if you listen to the fuel fill port with the fuel f ill cap removed. The fuel pump should run for 2 seconds when the ignition switch is first turned on. If the fuel pump does

© 2016-2025 Copyright www.hcrv.net