Honda CR-V: Garage Door Opener - If Equipped

HomeLink replaces up to three hand-held transmitters that operate devices such as garage door openers, motorized gates, lighting or home security systems. The HomeLink unit is powered by your vehicles 12 Volt battery.

The HomeLink buttons that are located in the overhead console designate the three different HomeLink channels.

Garage Door Opener - If Equipped
HomeLink Buttons

NOTE: HomeLink is disabled when the Vehicle Security Alarm is active.

READ NEXT:

 Before You Begin Programming HomeLink

Ensure your vehicle is parked outside of the garage before you begin programming. For efficient programming and accurate transmission of the radio-frequency signal it is recommended that a new batter

 Programming A Rolling Code

For programming garage door openers that were manufactured after 1995. These garage door openers can be identified by the "LEARN" or "TRAIN" button located where the hanging antenna is attached to the

 Programming A Non-Rolling Code

For programming Garage Door Openers manufactured before 1995. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand - held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLin

SEE MORE:

 TPMS (Tire Pressure Monitoring System)

Component Location Index TPMS CONTROL UNIT (Behind the dashboard center lower cover) Replacement TIRE PRESSURE SENSOR Replacement TIRE PRESSURE SENSOR Replacement UNDER-DASH FUSE/RELAY BOX TIRE PRESSURE SENSOR Replacement DATA LINK CONNECTOR (DLC) TIRE PRESSURE SENS

 Onboard Diagnostic System (OBD II)

Your vehicle is equipped with a sophisticated onboard diagnostic system called OBD II. This system monitors the performance of the emissions, engine, and automatic transmission control systems. When these systems are operating properly, your vehicle will provide excellent performance and fuel econom

© 2016-2023 Copyright www.hcrv.net