Honda CR-V: Frame
Under-cowl Panel Replacement
NOTE: Take care not to scratch the body.
1. Remove these items:
- Windshield wiper arms
- Front fender trim, both sides
- Cowl covers
2. Remove the bolts and nuts, disconnect the
connector (A) and remove the grommet (B), then
remove the under-cowl panel (C).

3. Install the under-cowl panel in the reverse order of
removal.
Upper Dashboard Support Gusset Replacement
Upper Dashboard Support Gusset Torque
NOTE: Take care not to scratch the body.

Rear Damper Gusset Replacement
Rear Damper Gusset Torque
NOTE: Take care not to scratch the body.

Subframe Replacement
Front Subframe Torque
NOTE:
- After loosening the subframe mounting bolts, be sure to replace them
with new ones.
- When installing, align both installation reference holes in the subframe
with both reference holes in the body using
a screwdriver or tapered punch as a guide.

Rear Subframe Torque
NOTE:
- After loosening the subframe mounting bolts, be sure to replace them
with new ones.
- When installing, align both installation reference holes in the subframe
with both reference holes in the body using
a screwdriver or tapered punch as a guide.

Frame Repair Chart
Top View


Side View


READ NEXT:
Special Tools
Backprobe set
Component Location Index
SERVICE VALVE (HIGH-PRESSURE SIDE)
SERVICE VALVE (LOW-PRESSURE SIDE)
EVAPORATOR CORE (Located-in the heater unit)
RECEIVER/DRYER DESIC
WARNING
Compressed air mixed with the R-134a forms a
combustible vapor.
The vapor can burn or explode causing serious
injury.
Never use compressed air to pressure test
R-134a service equipment
The air conditioning system removes heat from the passenger compartment by
transferring heat from the ambient air
to the evaporator. The evaporator cools the air with the refrigerant that is
circula
SEE MORE:
The service life of your tires is
dependent on many factors,
including, but not limited to, driving
habits, road conditions, vehicle
loading, inflation pressure,
maintenance history, speed, and
environmental conditions (even
when the tires are not in use).
In addition to your regular
DTC B1028: Rear Window Wiper Motor (As)
Signal Error
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN System
Diagnosis Test Mode A.
1. Clear the DTCs with the HDS.
2. Turn the. ignition switch OFF, and then back ON (II).
3. Operate the rear window wiper f
© 2016-2025 Copyright www.hcrv.net
