Honda CR-V: Windshield Wipers and Washers

READ NEXT:

 Windshield Wiper

1. MIST 2. OFF 3. INT Intermittent 4. LO Low speed 5. HI High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipers run at high speed until

 WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

SEE MORE:

 DTC P2227: BARD Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P0101, P0108, P1128, and/or P1129 are stored at the same time as DTC P2221, troubleshoot those DTCs first, then recheck for DTC P2221. 1. Turn the ignit

 Important Safety Precautions

To eliminate potential hazards, read the instructions before you begin, and make sure you have the tools and skills required. Make sure your vehicle is parked on level ground, the parking brake is set, and the engine is off. To clean parts, use a commercially available degreaser or par

© 2016-2026 Copyright www.hcrv.net