Honda CR-V: ThreeWay Catalytic Converter

The three way catalytic converter contains precious metals that serve as catalysts, promoting chemical reactions to convert the exhaust gasses without affecting the metals.

The catalytic converter is referred to as a three-way catalyst, since it acts on HC, CO, and NOx. A replacement unit must be an original Honda part or its equivalent.

The three way catalytic converter must operate at a high temperature for the chemical reactions to take place. It can set on fire any combustible materials that come near it. Park your vehicle away from high grass, dry leaves, or other flammables.

A defective three way catalytic

A defective three way catalytic converter contributes to air pollution, and can impair your engine’s performance.

Follow these guidelines to protect your vehicle’s three way catalytic converter.

Always use unleaded gasoline.

Even a small amount of leaded gasoline can contaminate the catalyst metals, making the three way catalytic converter ineffective.

Keep the engine well maintained.

Have your vehicle diagnosed and repaired if it is misfiring, backfiring, stalling, or otherwise not running properly.

READ NEXT:

 Emissions Testing

Testing of Readiness Codes If you take your vehicle for an emissions test shortly after the battery has been disconnected or gone dead, it may not pass the test. This is because of certain ‘

 Warranty and Customer Relations

 Customer Service Information

Honda dealership personnel are trained professionals. They should be able to answer all your questions. If you encounter a problem that your dealership does not solve to your satisfaction, pl

SEE MORE:

 Warranty Coverages

U.S. Owners Your new vehicle is covered by these warranties: New Vehicle Limited Warranty - covers your new vehicle, except for the battery, emissions control systems, and accessories against defects in materials and workmanship. Emissions Control Systems Defects Warranty and Emission

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch. 4. Inspect the connector terminals to be sure they are all making good contact. If the terminals a

© 2016-2026 Copyright www.hcrv.net