Honda CR-V: PCV System

Component Location Index

Honda CR-V. PCV System

PCV Valve Inspection

1. Check the PCV valve (A), hoses (B), and connections for leaks or restrictions.

Honda CR-V. PCV System

2. At idle, make sure there is a clicking sound from the PCV valve when the hose between the PCV valve and intake manifold is lightly pinched (A) with your fingers or pliers.

If there is no clicking sound, check the PCV valve washer for cracks or damage. If the washer is OK, replace the PCV valve and recheck.

Honda CR-V. PCV System

PCV Valve Replacement

1. Disconnect the PCV hose.

2. Remove the PCV valve (A).

Honda CR-V. PCV System

3. Install the parts in the reverse order of removal with a new washer (B).

READ NEXT:

 EVAP System

Component Location Index EVAPORATIVE EMISSION (EVAP) CANISTER PURGE VALVE Replacement POWERTRAIN CONTROL MODULE (PCM) General Troubleshooting Information Replacement

 DTC Troubleshooting

 DTC P0443: EVAP Canister Purge Valve Circuit Malfunction

Special Tools Required Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A or equivalent, commercially available. NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and revie

SEE MORE:

 A/C Condenser Fan High Speed Circuit Troubleshooting

NOTE: Do not use this troubleshooting procedure if the radiator fan and/or A/C compressor is inoperative. Refer to the symptom troubleshooting index. Before doing symptom troubleshooting, check for powertrain DTCs. 1. Check the No.6 (20 A) and No. 15 (7.5 A) fuses in the under-hood fuse/rela

 Windshield Wiper

1. MIST 2. OFF 3. INT Intermittent 4. LO Low speed 5. HI High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipers run at high speed until you release the lever. OFF - The wipers are not activated. INT - The wipers operate every few s

© 2016-2026 Copyright www.hcrv.net