Honda CR-V: APP Sensor Signal Inspection

NOTE:

1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.

Honda CR-V. APP Sensor Signal Inspection

2. Turn the ignition switch ON (II).

3. Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.

4. Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.

Accelerator Pedal Module Removal/Installation

1. Disconnect the accelerator pedal module connector (A).

Honda CR-V. Accelerator Pedal Module Removal/Installation

2. Remove the accelerator pedal module (B).

NOTE: The APP sensor is not available separately.

Do not disassemble the accelerator pedal module.

3. Install the parts in the reverse order of removal.

READ NEXT:

 VTEC/VTC

Component Location Index ROCKER ARM OIL CONTROL VALVE Removal/Installation ROCKER ARM OIL PRESSURE SWITCH Removal/Installation CAMSHAFT POSITION (CMP)

 DTC Troubleshooting

 DTC P0010: VTC Oil Control Solenoid Valve Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the H

SEE MORE:

 Information Display

As an incoming call notification, you will see the following display: A notification that there is an incoming call, or HFL is in use, will appear on the navigation screen when the audio system is on. When there is an incoming call, or HFL is in use, ‘‘HFL’’ will appear at

 Adding Engine Oil

Unscrew and remove the engine oil fill cap on top of the valve cover. Pour in the oil slowly and carefully you do not spill any. Clean up any spills immediately. Spilled oil could damage components in the engine compartment. Reinstall the engine oil fill cap, and tighten it securely.

© 2016-2025 Copyright www.hcrv.net