Honda CR-V: APP Sensor Signal Inspection

NOTE:

1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.

Honda CR-V. APP Sensor Signal Inspection

2. Turn the ignition switch ON (II).

3. Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.

4. Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.

Accelerator Pedal Module Removal/Installation

1. Disconnect the accelerator pedal module connector (A).

Honda CR-V. Accelerator Pedal Module Removal/Installation

2. Remove the accelerator pedal module (B).

NOTE: The APP sensor is not available separately.

Do not disassemble the accelerator pedal module.

3. Install the parts in the reverse order of removal.

READ NEXT:

 VTEC/VTC

Component Location Index ROCKER ARM OIL CONTROL VALVE Removal/Installation ROCKER ARM OIL PRESSURE SWITCH Removal/Installation CAMSHAFT POSITION (CMP)

 DTC Troubleshooting

 DTC P0010: VTC Oil Control Solenoid Valve Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the H

SEE MORE:

 A/C Signal Circuit Troubleshooting

NOTE: Use this troubleshooting procedure if the A/C compressor, the A/C condenser fan, and radiator fan are inoperative. Before doing symptom troubleshooting, check for and resolve any powertrain DTCs. 1. Turn the ignition switch ON (II). 2. Check if the blower motor operates at all speeds.

 Modifying Your Vehicle

Removing parts from your vehicle, or replacing components, with non-Honda components could seriously affect your vehicle’s handling, stability, and reliability. Here are some examples: Lowering the vehicle with a non- Honda suspension kit that significantly reduces ground clearance

© 2016-2026 Copyright www.hcrv.net