Honda CR-V: HazardWarning Button

Push the button between the center

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel to flash. Use the hazard warning lights if you need to park in a dangerous area near heavy traffic, or if your vehicle is disabled.

READ NEXT:

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

 Parking Brake

To apply the parking brake, push the pedal down with your foot. To release it, push on the pedal again. The parking brake indicator on the instrument panel should go out when the parking

 Steering Wheel Adjustment

Make any steering wheel adjustment before you start driving. Adjusting the steering wheel position while driving may cause you to lose control of the vehicle and be seriously injured in

SEE MORE:

 DTC P0973: Short in Shift Solenoid Valve A Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission. 1. Clear the DTC with the HDS. 2. Start the

 VSA (Vehicle Stability Assist) System Components

Component Location Index VSA MODULATOR-CONTROL UNIT Removal and Installation UNDER-HOOD FUSE/RELAY BOX DATA LINK CONNECTOR (DLC) STEERING ANGLE SENSOR Replacement VSA OFF SWITCH Test RIGHT-REAR WHEEL SENSOR Replacement HUB BEARING UNIT (MAGNETIC ENCODER) Replace

© 2016-2025 Copyright www.hcrv.net