Honda CR-V: Disconnecting a USB Flash Memory Device

You can disconnect the USB flash memory device at any time even if the USB mode is selected on the audio system. Always follow the USB flash memory device’s instructions when you remove it.

When you disconnect the USB flash memory device while it is playing, the display shows ‘‘NO DATA.’’

If you reconnect the same USB flash memory device, the system will begin playing where it left off.

READ NEXT:

 USB Flash Memory Device Error Messages

If you see an error message on the audio display while playing a USB flash memory device, find the solution in the chart to the right. If you cannot clear the error message, take your vehicl

 Playing the AM/FM Radio (EX-L model with navigation system)

 Playing the AM/FM Radio (EX-L model with navigation system)

Playing the AM/FM Radio (EX-L model with navigation system)

SEE MORE:

 DTC P0300: Random Misfire and Any Combination of the Following

DTC P0301: No.1 Cylinder Misfire Detected DTC P0302: No.2 Cylinder Misfire Detected DTC P0303: No.3 Cylinder Misfire Detected DTC P0304: No.4 Cylinder Misfire Detected Special Tools Required Pressure gauge adapter 07NAJ-P07010A A/T low pressure gauge w/panel 07406-0070301 A/T pressure hose 07406

 Low Oil Pressure Indicator Circuit Troubleshooting (Open)

1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2). 2. Turn the ignition switch ON (II). 3. Make sure the HDS communicates with the vehicle and the powertrain control module (PCM). If it doesn't communicate, troubleshoot the DLC circuit. 4. Check for DTCs.

© 2016-2025 Copyright www.hcrv.net