Honda CR-V: Fluid Locations
Honda CR-V (2006–2011) Owner's Manual / Maintenance / Fluid Locations
Fluid Locations
READ NEXT:
Adding Engine Oil
Unscrew and remove the engine oil
fill cap on top of the valve cover.
Pour in the oil slowly and carefully
you do not spill any. Clean up any
spills immediately. Spilled oil could
damage co
Recommended Engine Oil
Oil is a major contributor to your
engine’s performance and longevity.
Always use a premium-grade 0W-20
detergent oil displaying the API
Certification Seal. This seal indicates
the oil is e
Synthetic Oil
You may use a synthetic motor oil if
it meets the same requirements
given for a conventional motor oil: it
displays the API certification seal,
and it is the proper weight. You must
follow t
SEE MORE:
Audio Unit Removal/Installation
Without navigation
SRS components are located in this area. Review the
SRS component location.
Also review the precautions and procedures in the SRS section before doing repairs or
service.
NOTE:
Put on gloves to protect your hands.
Take care not to scratch the dashboard and related
parts.
Lay
Front Driveshaft Installation
1. Apply grease to the contact area (A) of the outboard
joint and front wheel bearing.
NOTE: Failure to apply grease may cause excessive
noise and vibration.
2. Install a new set ring (A) onto the set ring groove
(B) of the driveshaft (left driveshaft).
3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease
© 2016-2025 Copyright www.hcrv.net
