Honda CR-V: Fluid Locations
Honda CR-V (2006–2011) Owner's Manual / Maintenance / Fluid Locations
Fluid Locations
READ NEXT:
Adding Engine Oil
Unscrew and remove the engine oil
fill cap on top of the valve cover.
Pour in the oil slowly and carefully
you do not spill any. Clean up any
spills immediately. Spilled oil could
damage co
Recommended Engine Oil
Oil is a major contributor to your
engine’s performance and longevity.
Always use a premium-grade 0W-20
detergent oil displaying the API
Certification Seal. This seal indicates
the oil is e
Synthetic Oil
You may use a synthetic motor oil if
it meets the same requirements
given for a conventional motor oil: it
displays the API certification seal,
and it is the proper weight. You must
follow t
SEE MORE:
Valve, Spring, and Valve Seal Installation
Special Tools Required
Stem seal driver 07PAD-001 0000
Valve spring compressor attachment 07757-PJ1010A
1. Coat the valve stems with engine oil. Install the
valves in the valve guides.
2. Check that the valves move up and down smoothly.
3. Install the spring seats on the cylinder head.
4. Ins
F-CAN Circuit Troubleshooting
NOTE: Information marked with an asterisk (*) applies
to the CANL line.
1. Turn the ignition switch OFF.
2. Jump the SCS line with the HDS.
3. Disconnect PCM connector A (44P), then disconnect
the HDS.
4. Measure resistance between PCM connector
terminals A36 and A37.
Is there about 95- 116 Ω
© 2016-2025 Copyright www.hcrv.net
