Honda CR-V: Instrument Panel Brightness
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Instrument Panel Brightness
You can change the instrument panel brightness only when the light switch is on.
Turn the knob on the lower part of the instrument panel to adjust the brightness.
You will hear a beep when maximum or minimum brightness is reached.
To reduce glare at night, the
instrument panel illumination dims
when you turn the light switch to
or 
.
Turning the select/
reset knob fully to the right until you
hear a beep will cancel the reduced
brightness.
READ NEXT:
HazardWarning Button
Push the button between the center
vents to turn on the hazard warning
lights (four-way flashers). This
causes all four outside turn signals
and both indicators in the instrument
panel t
Rear Window Defogger
The rear window defogger will clear
fog, frost, and thin ice from the
window. Push the defogger button to
turn it on and off. The indicator in
the button comes on to show the
defogger is
Parking Brake
To apply the parking brake, push the
pedal down with your foot. To
release it, push on the pedal again.
The parking brake indicator on the
instrument panel should go out when
the parking
SEE MORE:
PCM Replacement
NOTE:
Make sure the HDS is loaded with the latest software
version.
If you are replacing the PCM after substituting a
known-good PCM, reinstall the original PCM, then do
this procedure.
During the procedure, is any READ DATA, WRITE
DATA, or other data checks fail, note the failure, then
con
DTC 71-2x ("x" can be 0 thru 9 or A thru F):
Short in Driver's Seat Position Sensor
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures.
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on, and is DTC 71-2x
indicated?
YES-G
© 2016-2025 Copyright www.hcrv.net
