Honda CR-V: Driving Guidelines

Your vehicle has higher ground clearance that allows you to travel over bumps, obstacles, and rough terrain. It also provides good visibility so you can anticipate problems earlier.

Because your vehicle rides higher off the ground, it has a high center of gravity that can cause it to roll over if you make abrupt turns. Utility vehicles have a significantly higher roll over rate than other types of vehicles.

To prevent rollovers or loss of control:

Take corners at slower speeds than you would with a passenger vehicle.

Avoid sharp turns and abrupt maneuvers whenever possible.

Do not modify your vehicle in any way that would raise the center of gravity.

Do not carry heavy cargo on the roof.

Four-wheel drive models

Your vehicle is equipped with a fourwheel drive (4WD) system. When the system senses a loss of frontwheel traction, it automatically transfers some power to the rear wheels. This gives you better traction and mobility.

READ NEXT:

 Preparing to Drive

You still need to exercise the same care when accelerating, steering, and braking that you would in a twowheel drive vehicle. 1. Make sure all windows, mirrors, and outside lights are clean a

 Starting the Engine

1. Apply the parking brake. 2. In cold weather, turn off all electrical accessories to reduce the drain on the battery. 3. Make sure the shift lever is in Park. Press on the brake pedal. 4. W

 Automatic Transmission

SEE MORE:

 Valve, Spring, and Valve Seal Installation

Special Tools Required Stem seal driver 07PAD-001 0000 Valve spring compressor attachment 07757-PJ1010A 1. Coat the valve stems with engine oil. Install the valves in the valve guides. 2. Check that the valves move up and down smoothly. 3. Install the spring seats on the cylinder head. 4. Ins

 Reminder Systems

Component Location Index GAUGE CONTROL MODULE MICU Circuit Diagram Control Unit Input Test NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. MICU 1. Turn the ignition switch OFF. 2. Remove the left kick panel. 3. Disconnect the under-dash fuse/relay box connectors.

© 2016-2025 Copyright www.hcrv.net