Honda CR-V: Information Display
As an incoming call notification, you will see the following display:
A notification that there is an incoming call, or HFL is in use, will appear on the navigation screen when the audio system is on.
When there is an incoming call, or HFL is in use, ‘‘HFL’’ will appear at the bottom of the map screen.
However, when the current street is shown, and AUDIO INFO icon is visible, ‘‘HFL’’ will not appear when there is an incoming call.
The Bluetooth icon 
will also
appear on the display when a phone
is linked.
READ NEXT:
How to Use HFL
To use HFL, you need to pair your
Bluetooth-compatible cell phone to
the system.
Phone Setup
This command group is available for
paired cell phones.
Phone pairing tips
You cannot pair your phone while
the vehicle is moving.
Your phone must be in discovery
or search mode to pair. Refe
Bluetooth Wireless Technology
The Bluetooth name and logos are
registered trademarks owned by
Bluetooth SIG, Inc. and any use of
such marks by Honda Motor Co.,
Ltd. is under license. Other
trademarks and trade names are
SEE MORE:
DTC P1157: A/F Sensor (Sensor 1) AFS Circuit
High Voltage
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine, and wait 1 minute.
4. Check for Temporary DTCs or DTCs with the HDS.
Is DT
Radio Theft Protection
Your vehicle’s audio system will
disable itself if it is disconnected
from electrical power for any reason.
To make it work again, you must
enter a specific code using the preset
buttons (icon on vehicle’s with
navigation system). Because there
are hundreds of number
combinations
© 2016-2026 Copyright www.hcrv.net
